Safety tips for equipment wiring

Safety tips for equipment wiring

• Equipment assembly, wiring, maintenance, inspection or component replacement shall be performed by professionals!
• Please power off all equipment before wiring. It is necessary to discharge the residual voltage and make sure it is below the safe voltage, otherwise there will be electric shock hazard.
• Please conduct wiring work, remove the product cover or touch the circuit board when the power supply is cut off, otherwise there will be electric shock hazard.
• Please be sure to ensure good grounding of equipment and products, otherwise there will be electric shock hazard and real-time performance cannot be guaranteed.
• It is strictly prohibited to connect the input power supply to the output end of the product, otherwise it may cause equipment damage or even fire.
• It is strictly prohibited to reverse polarity connection. Please follow the product instructions for wiring, otherwise the equipment will be damaged.
• The cable used for wiring must meet the requirements of corresponding wire diameter, shielding and other aspects, and the shielding layer of the shielded cable shall be reliably grounded at one end!
• Please tighten the terminal screws according to the tightening torque specified in the manual to avoid insufficient or excessive tightening torque.
• After completing wiring, please ensure that all cables are properly wired and that there are no missing screws, gaskets, or exposed cables inside the product.