| ID |
Name |
Remarks |
| ① |
Nixie tube display |
5 digit 7 segment LED digital tube |
| ② |
Key-type operator |
Operation mode, with settings of functions, parameters andmonitoring |
| ③ |
CHARGE(Bus voltage indicator) |
Power indicator light |
| ④ |
L1C, L2C(Control power input terminal) |
Control power supply of loop, connect to single phase power supply(depending on model 200~240VAC or 380~440VAC,50/60Hz power supply) |
| R/S/T(Main power input terminal) |
Main loop power supply, connect to single/three phase power supply(depending on model 200~240VAC or 380~440VAC,50/60Hz power supply) |
| P, RB, B(Regenerative resistorconnection terminal) |
Use external regenerative resistor(remove the shorting cap of Pand RB; Connect it to both ends of P and B) |
| P/N1/N2(Common DC busterminals) |
Do not remove the shorting cap between N1 and N2. Connect itbetween P and N1 for common DC bus of multiple servos |
| U/V/W(servo motor connectionterminal) |
Servo drive output, connected to motor power connector(U/V/W) |
| ⑤ |
CN1(Mini USB) |
Mini USB port, connected to PC |
| ⑥ |
CN2(Connector for safety function) |
STO connector, only 'P/E/F' models support this option |
| ⑦ |
CN3(I/O Connector) |
I/O signals are connected to programmable controller (PLC) orcontrol I/O with connectors |
| ⑧ |
CN4(Encoder connector) |
Encoder connector, connected to the encoder on servo motor |
| ⑨ |
CN5(Fully Closed Loop EncoderConnector) |
Fully closed loop connector, connected to th external secondencoder. This function is supported by '-*C/*G' models |
| ⑩ |
Ground screw |
Connect to earth wires of power supply and motors |
