Port configuration description
The ports of the SRI8000-4A0B-E can adapt to various modes.
| Interface | Parameter setting description |
| X01~X04 |
IO-Link: The interface is used for IO-Link communication and can connect IO-Link modules; If IO-Link mode is selected for a port and I/Q Config is set to Class A, pin 2 of that port can be used as I/Q Input, a digital PNP-type input. If IO-Link mode is selected for a port and I/Q Config is set to Class B, pin 2 of that port provides a 24 V output. Input: C/Q Input: interface pin 4 is configured as digital PNP input; I/Q Input: interface pin 2 is set as a digital PNP-type input (default); I/Q Output: interface pin 2 is configured as digital PNP output; C/Q Output PNP: C/Q Output: interface pin 4 is configured as digital PNP output; I/Q Input: interface pin 2 is set as a digital PNP-type input (default); I/Q Output: interface pin 2 is configured as digital PNP output; C/Q Output NPN: C/Q Output: interface pin 4 is configured as digital NPN output; I/Q Input: interface pin 2 is set as a digital PNP-type input (default); I/Q Output: interface pin 2 is configured as digital PNP output; |
Note:
- The default is IO-Link mode; pay attention to the port Class type when using.
- In Class A mode, PIN2 I/Q defaults to I/Q Input; to set it to I/Q Output, this function must be enabled on the web page, and I/Q output must be selected under the "I/Q Config" directory of the corresponding port.
Port type configuration description
The IO-Link interface of the SRI8000-4A0B-E can be configured as a Class A or Class B interface; when Class A needs to be changed to Class B during use, log in to the web page, select the port number to be configured, and in IO-Link mode, switch Class A to Class B via the parameter configuration drop-down list; at this time, PIN2 has a 24 V output:
I/Q Output configuration description
I/Q PIN2 output configuration: to configure PIN 2 as an output, enable this function by selecting "Enable" in the "I/Q Output" drop-down list; [after the I/Q Output output configuration is enabled, select the corresponding port and choose "I/Q Output PNP" under the "I/Q Config" directory]; the corresponding port's I/Q is then in the output state: